All your requests have now been added into the Micro MinimOSD! With all the features of the popular Witespy KV Team modded OSD but in a smaller 15x15mm size. The only difference is that it does NOT have the DC/DC converter. This means less heat when powered from a flight controller.
The RTF Micro MinimOSD is the same as the older MinimOSD hardware, but has been modified to take advantage of custom firmware options. You can choose firmware that is MAVLink compatible for ArduCopter, or MultiWii Serial compatible for MultiWii and Baseflight/Cleanflight control boards. You can connect two batteries up to 4S so you can see the main flight battery voltage and the second port will allow your FPV battery voltage to be displayed as well. Further, we did not forget about the pin for analog or digital PWM RSSI and included a connection where you can attach a current sensor.
Features:
- All the same features as the orgnal, but less than half the size
- NO DC/DC power conversion via 5 volts
- FTDI cable compatible pin-out
- Standard 6-pin ISP header
- Two LED indicators
- ATmega328P with Arduino bootloader
- MAX7456 monochrome on-screen display
- 15x15mm size board
- Modifications for direct connection of two batteries (up to 4S)
- Pad for an Analog or Digital PWM RSSI signal
- Pad for the connection of a Current Sensor
- ATmega328P with Arduino bootloader
- Standalone, or with APM/ Flip / Flip32+ flight controllers
- ATmega328P with Arduino bootloader
- MAX7456 monochrome on-screen display
- FTDI cable compatible pinout
- Standard 6-pin ISP header
- Two independent power sections with an LED indicator on each
- Solder jumpers for combining the power sections
- +5V 500mA regulator for up to +12V supply input
- Solder jumper for PAL video option
- Exposed test points for HSYNC and LOS
- Dimensions: 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H
